Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #3536
    Alex Wimbush
    Participant

      what does everyone use? I have been using 17psf which follows TPIC requirements, which obviously doesn’t apply to EWP, but seems like a good starting point.

       

      #3623
      Executive Director
      Participant

        test reply

        #3621

        Hey Alex,  good idea to look to TPIC as a starting point.  I would caution however that TPIC 2019 no longer reports a nominal PSF equivalent.  As a result, some municipalities may use a conversion factor to determine minimum loads in PSF, which will be slightly higher than the previously stated nominal values:

      Viewing 3 posts - 1 through 3 (of 3 total)
      • You must be logged in to reply to this topic.